MRA DUCATI Supersport S 2017 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA-Screen
3 Fillister head screw M5 x 16mm
3 Plastic washers 12 x 5 x 0,5mm
3 Spacer 6mm
3 O-Rings 4,5 x 1,5mm
1 Edge protection strip, sleeves
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the fastening screws and the original fairing screen.
3. Insert the M5 x 16mm screws with the plastic washers into the holes on the MRA
screen. Place the spacers onto the screws from inside.
Tip:
Place the O-rings supplied onto the screws after you've fitted the spacers, as this will
help you mount the screen (P 2).
4. Position the fairing screen and tighten the screws.
5. Fit the protective edge strip on the rear exposed part of the screen as shown in Figure
3. Cut off the rest if required.
6. Push the clamping sleeves over the ends of the protective edge strip and lightly
compress these using a pair of pliers to secure the edge strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Ducati Supersport S 2017-
Article No..
--- Allen key 3 + 4mm
10554
10635
11038
10992
---
3
Required tools