Dimmer Function - Dupla Nano Lux Mode D'emploi

Scope of delivery:
1x Nano Lux LED 18 W light with cable
connection (waterproof per IPX 7)
1x bracket
1x power supply Nano Lux LED 20 W
1x operating instructions
Operation:
The daily on times can easily be controlled
with a timer switch*.
Depending on the plants in the aquarium, one Ocean Lux LED 18 W light with suffice for the recommended aquari-
um sizes. For dense plantings or when keeping plants which require a high amount of light, we recommend using a
second Nano Lux Led 18 W light. *not included

Dimmer function:

With the Nano Lux LED dimmer you can adjust the brightness to the respective aquarium needs and further activate
blue moonlight:
· Press the ON/OFF button
· Press the
setting is approx. 843 lm, the lowest setting approx. 120 lm.
· Repeatedly press the ON/OFF button
· The brightness of the moonlight can also be adjusted by pressing the
· Repeatedly press the ON/OFF button
Note:
When using a timer switch, the Nano Lux LED will always us the last setting when switched on. The preset dimming
level remains unchanged. If the light was last in moonlight, the Nano Lux LED will switch on with this setting.
Cleaning: Clean the Nano Lux LED with a soft, damp cloth. Disconnect the mains plug and allow the LED lamp to
cool down before cleaning the LED light. Do not use harsh cleaners or solvents to prevent damaging the surface!
Warranty terms: In the event of a warranty claim, please contact your speciality retailer or return the unit along
with a valid receipt of purchase with sufficient postage to Dupla Customer Service.
You can find the warranty card with the warranty terms in the Service section of our website: www.dupla.com
Disclaimer: Dohse Aquaristik GmbH & Co. KG assumes no liability for damages resulting from use of the device.
Declaration of conformity: The manufacturer certifies the devices comply with EMC Directive 2014/30/EU, Low
Voltage Directive 2014/35/EU & ROHS Directive 2011/65/EU.
Technical data:
· colour temperature: 5,100 K
· lumen: 843 lm
· LED: RGBW
· colour reproduction: CRI: 85
· LED beam angle: 120°
· output: 18 W
· LED light dimensions: 35 x 9 x 2 cm
· dimensions LED with brackets: 35 – 50 cm
Tel.: +49 (0) 22 25 - 94 15 0 · info@dohse-aquaristik.de · www.dupla.com
880_Geba_Dupla_Nano_Lux_LED_18W_DINA6_Heftung_RZ_190423.indd 7
to switch on the Nano Lux LED.
or button to adjust the LED brightness. Choose from up to 16 different brightnesses. The brightest
Caution: The power supply is only suitable to operate LED lights. The power supply / mains adapter may only
be used with suitable Dupla components (Nano Lux LED).
, to switch to blue moonlight.
to switch off the Nano Lux LED.
or button.
7
23.04.19 13:2