Changing The Lamp - ANSMANN ASN 15HD+ Manuel D'utilisation

1 blinking BLUE LED: When the remaining battery capacity is reached, it is possible to switch over to the energy sparing
lamp (remaining light duration > 2 h)
Emergency light function: (power failure electronics)
Should the power supply fail while the lamp is parked in the wall bracket for charging, the main lamp begins to burn
until the supply voltage has been restored or the discharge limit of the battery is reached. It is possible to switch off
the portable search light manually.
Repair and maintenance:
Repair work may only be carried out by professionally trained electricians!
Only original replacement parts may be used!
cHANGING tHe BAttery:
Please proceed as follows:
> Disengage (2) switches, left and right on the base.
> Remove the old battery.
> Insert the new battery.
> Re-engage the two switches, left and right on the base.
Used batteries should be brought to recycling and do not belong with the household garbage!
construction of the portable search light:
1. Battery capacity display through 4 BLUE LED.
2. Operation selection control switch.
3. Charge socket Input 12 V-24 V.
4. Wall bracket with integrated charging electronics.
5. Search light head with halogen lamp.
6. Energy saving lamp with 4 high performance LEDs on the underside of the portable search light.
7. Colour filters attachment available as an option. (orange and red – NOT included in the scope of supply).
9. Housing with integrated lamp control system.

cHANGING tHe lAMP

Please proceed as follows:
> Open the lamp rings by pressing the switch on the lamp head upper side
> Carefully remove the lamp ring with the reflector
> Cautiously remove the lamp, forwards
> Grasp the new lamp with cloth, and insert it into the prescribed opening
> Insert the reflector, while paying careful attention that the given lamp is not damaged
> When closing the lamp ring, pay careful attention that the underside is attached first, and that afterwards the
upper side is pressed until it catches.