Controls And Jacks - BizLine BIZ 780 312 Mode D'emploi

EN
2. USE EXTREME CAUTION when working with high voltages.
3. DO NOT measure voltage if the voltage on the "COM" input jack exceeds
1000V above earth ground
4. NEVER connect the meter leads across a voltage source while the function
switch is in the current, resistance, CAD or diode mode. Doing so can damage
the meter.
5. ALWAYS discharge filter capacitors in power supplies and disconnect the power
when making resistance or diode tests.
6. ALWAYS turn off the power and disconnect the test leads before opening the
covers to replace the fuse or batteries.
7. NEVER operate the meter unless the back cover and the battery and fuse
covers are in place and fastened securely
8. If the equipment is used in a manner not specified by the manufacturer, the
proctection provided by the equipment may be impaired.

3. Controls and Jacks

1-6000 counts LCD display
2-MAX/MIN button
3-RANGE button
4-Mode button
5-Function switch
6-mA, µA and 10 A input jacks
7-COM input jack
8-Positive input jack
9-HOLD and Backlight button
10-Hz and % button
11-RELATIVE button
Note : Tilt stand and battery compartment are on rear of unit.
5
e_Notice_BIZ780312_EN-FR-NL.indd 5 15/05/2019 17:3