Wagan Tech Easy Quick Jumper 9796 Guide D'utilisation page 2

Easy Quick Jumper
OpERATIng InsTRuCTIOns
1. Make sure the lamps, stereo, air condition, and all other accessories on
both vehicles are turned off.
2. Connect the short, black plug to the "live" vehicle with the functioning
battery.
3. Connect the red plug with the longer power cord to the vehicle with
the dead battery. switch the ignition lock of the dead vehicle to the
"ACCEssORY" position.
4. Then start the engine of the vehicle with the functioning battery; the red LED
will turn on.
5. About 10 minutes later, when the red LED turns to green, start the engine of
the dead vehicle.
6. Once the engine on the dead vehicle starts, remove the plugs from the
cigarette lighter sockets on both vehicles.
7. Allow the engine on the "just-started" vehicle to warm up to operating
temperature before driving.
8. no recharging system will help a battery that is depleted, shorted internally
or malfunctioning, under such condition, please replace the battery.
TROubLEshOOTIng
Problem:
The green LED power indicator going to the operating vehicle does not illuminate
when the plug with shorter cord is inserted into cigarette lighter socket.
Possible Causes:
1. The black plug is not fully inserted into the cigarette lighter socket.
2. The engine of the operating vehicle is not running.
2
by Wagan Tech®
™
www.wagan.com