Geemarc CLEARSOUND AMPLICALL 20 Guide Rapide page 9

Note: Do not use a rechargeable battery. Do not put the
used battery into the household rubbish, pay attention to
battery regulations regarding battery disposal.
The Pairing Procedure
1. Press and hold the Pairing/Test button until the unit
makes a beep sound, then release the Pairing/Test
button. The 1
pairing mode has been entered.
2. Press and hold the Pairing/Test button again until the
st
1 LED flashes, then press and hold the remote
button at the same time until the strobe flasher
flashes. The unit makes a beep sound to confirm
pairing has been successful.
3. If the user wants to pair a 2
st
the 1 LED lights, press the Pairing/Test button once,
st
the 1 LED goes off and then the 2
The user is then able to pair the 2
the same procedure for the 3
4. Repeat the above, all 3 LEDS flashing together for
th
the 4 remote pairing.
INSTALLATION
st
LED lights to indicate that the
nd rd
and 3
nd
nd
remote. Repeat
rd
remote.
8
remote, when
LED lights.