Geemarc CLEARSOUND AMPLICALL 20 Guide Rapide page 12

When there is an
incoming call but the
shaker doesn't
vibrate.
The Amplicall20
does not ring when
the doorbell is
pressed
INSTALLATION
1) Check it is connected to the
2) Check the shaker socket to
3) Check the alarm mode
1) Check that the red light on
2) Register the doorbell to the
3) Check the alarm mode
11
shaker correctly.
see if it has been damaged.
selection switch position is
correct.
the doorbell flashes when it
is pressed. If it does not,
change the battery.
AmpliCALL20 again
selection switch position is
correct i.e. not on '0'