Your First Gostudio Recording - Belkin GoStudio F8Z295 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

oVeRVIeW
seCTions
Table of Contents

Your first GoStudio Recording

It only takes a few minutes to set up your GoStudio and start recording.
let's walk through your first recording so you can get familiar with the GoStudio's controls . all you need is your GoStudio, your iPod, and the
two aaa batteries that came with the GoStudio . for more details about how these controls work, see the "GoStudio Controls" section on
page 10 .
To make your first GoStudio recording:
1
Make sure the GoStudio's power switch is in the off position. The power switch is located toward the bottom of the control panel.
2
Remove the battery door on the rear of the GoStudio and install two AAA batteries.
3
Switch the GoStudio power switch to the on position. Check that the GoStudio's status indicator, located directly above the power switch, is green.
4
In the next few steps, we'll set the audio controls to record using the GoStudio's built-in microphones.
Set the GoStudio's Source switch, located on the left side of the control panel, to the lowest position. This tells the GoStudio that you want to
5
record using the on-board mics.
Set the 01 gain switch, located on the upper-left side of the control panel, to the auto position. This configures the GoStudio to provide
6
amplification that adapts to the audio that's being recorded. In this case, the auto setting will work well for recording using the on-board
microphones in many situations. Don't worry about the gain 02 switch, as this control does not apply when using the on-board microphones.
7
Set the master level control knob so that it points to the 0 marking, which is between the 2:00 and 3:00 position of the knob's rotation. Setting this
knob to the 0 point tells the GoStudio not to apply any extra attenuation or amplification to the audio signal.
8
Set the optional mono, limiter, and low cut filter control switches to the off position. These controls are located on the right side of the control
panel.
GoStudio
1
2
3
4
4
5
6

Publicité

Table des Matières
loading

Table des Matières