Troubleshooting - Belkin GoStudio F8Z295 Guide D'utilisation

TRoUbleSHooTInG

seCTions
Table of Contents
Most problems with your GoStudio can be solved quickly by
following the advice in this chapter .
If you continue to have trouble, contact Belkin Customer Service at
800-223-5546 ext . 2263 or on the web at http://www .belkin .com/
support .
If your GoStudio won't turn on:
• Make sure you're using new AAA batteries or an AC power supply
that meets the requirements listed in the "Specifications" section of
this manual. You may damage your GoStudio and/or your iPod if you
do not use a compatible power supply.
• Make sure the GoStudio's power switch is set to the on position. Or,
if the power switch is set to the on with iPod position, make sure
your iPod is awake and operational.
• Try using another power outlet.
GoStudio
1 2 3 4
If you don't hear anything in the speaker or
headphones:
• Make sure your GoStudio is powered and the power switch is in the
on position.
• Make sure the headphone cable is securely connected.
• Turn up the level control(s).
• Remember that the speaker is only used when playing back audio
from an iPod. The speaker is not used to listen to your audio inputs
in real time.
If these suggestions don't help, you might have a bad cable. Check all of
your cables and try replacing them with known good ones.
If the microphone volume is too low:
• Make sure the cables are securely connected.
• If the microphone is connected, or you're using the on-board mics,
turn up the gain control switch.
• Consider moving the microphones closer to the audio source.
20
5 6