AEG KM3 Série Mode D'emploi page 9

• Switch off the appliance and disconnect from supply before changing accessories or
approaching parts that move in use.
• UNPLUG FROM OUTLET WHEN NOT IN USE, BEFORE INSERTING OR REMOVING
PARTS AND BEFORE CLEANING.
TROUBLESHOOTING
PROBLEM
The motor slows down during
operation.
The appliance does not start.
The appliance vibrates/moves
during operation.
DISPOSAL
This symbol on the product indicates that this product contains a battery which shall not be disposed with normal
household waste.
This symbol on the product or on its packaging indicates that the product may not be treated as household waste. To
recycle your product, please take it to an official collection point or to an AEG service center that can remove and recycle
the battery and electric parts in a safe and professional way. Follow your country's rules for the separate collection of
electrical products and rechargeable batteries.
AEG reserves the right to change products, information and specifications without notice.
www.aeg.com
POSSIBLE CAUSE
Amount of dough may exceed maximum
capacity.
Dough may be too wet, it sticks onto the
side of the bowl.
The appliance is not connected to the
mains.
The speed selector was not in "0" position
when the machine was plugged and
unplugged.
The blender is not fixed in the correct
position.
The rear attachment hub cover is not in
place or properly assembled.
The motor head is in the upper position.
The suction feet are not fixed to the
surface properly.
It is normal for heavy loads (e.g heavy
dough, cheese).
SOLUTION
Remove half and process in two batches.
Add more flour, 1 tablespoon at a time until the
motor speeds up. Process until dough cleans the
side of the bowl.
Make sure to plug in the appliance before
operation.
Turn the speed selector to "0" position, and then
to the desired speed.
The blender handle should point towards the
back of the machine when properly fixed.
Attach the rear attachment hub cover by
pushing it straight forward until locked into
position.
Set the speed selector to "0". Tilt the motor
head down. Move the speed selector from "0" to
desired speed (1-6).
Make sure the suction feet are clean. Place the
machine on a smooth and shiny surface.
Remove half and process in two batches.
GB
DE
AR
ES
FA
FR
GR
NL
PT
9