MediaShop ARTIC AIR 17023-G Mode D'emploi page 10

purpose, please contact our
customer service. You will find the
contact details on the last page of the
instruction manual.
• If the supplied cable does not work
correctly, please contact customer
service in order to avoid possible
dangers.
• When removing the cover for
changing of the filter, the ventilator
switches itself off and the water tank
begins to blink red until the cover is
put back on. This is a safety device.
TIPS:
• Place the Arctic Air™ on a raised
surface, something like a dining table,
desk or a sideboard.
• After refilling of the water tank and
before use, let the filter absorb water for
at least 3 minutes. This will provide you
quicker with cooler air.
• You will feel the best effect if
you sit directly in front of the
Arctic Air™
• With one filling the Arctic Air™ operates
at the lowest level for approximately 8
hours. Also when the water tank is
already empty, the filter remains damp
and the Arctic Air™ continues to cool.
• The colder the water used, the cooler
the effect. You may, therefore, also use
iced water or water with ice cubes.
SETTING UP:
1. Place the Arctic Air™ on a level base
(see illustration 1).
2. Open the water tank and fill it up
10
(see illustration 2). For this we
recommend a jug or beaker.
3. Plug the broader end of the cable into
the power supply (SW-050150EU) and
connect the power supply to a socket.
Then plug the narrower end of the
cable into the connection jack on the
rear side of the Arctic Air™
(see illustration 3). NOTE: You can
also connect the broader USB-end to
a computer. (DC 5V, 1,5A – 2,0A)
USE:
1. Press the on/off switch to power up the
Arctic Air™ (see illustration 4).
2. Set the speed of the ventilator by
pressing the control switch. You have a
choice of three modes - LO, MED and
HI (low, medium and high). The display
lights beside the switch will show you at
which speed the Arctic Air™ is currently
operating (see illustration 5).
3. Select the light colour by pressing the
control switch. You have the choice of
continual colours or colour-changing
mode (see illustration 6).
COLOUR SEQUENCE: Blue, red, white,
blue-green, purple, yellow, green.
When you have clicked through all the
colours, the mood light goes out and
the device will continue automatically.
4. To switch off press the on/off switch
again. NOTE: We recommend leaving
the Arctic Air™ to run for at least 5
minutes in the highest mode before
switching off, so that it can dry out.
LOW WATER LEVEL: If the water level is
low, the tank will blink three times, every
60 seconds in the colour YELLOW. When