Bluetooth® Connection; Cleaning And Care - Soehnle AIRFRESH CLEAN CONNECT 500 Mode D'emploi

Bluetooth® connection
You can connect the Airfresh Clean Con-
nect 500 to a Bluetooth® enabled mobile
device that has the Soehnle Connect app
installed. To do so, briefly press the (I)
button on your Clean Connect 500. You
can see if the Bluetooth® is switched on
when the - symbol lights up on the
Clean Connect 500 display. Press (I) again
to turn off Bluetooth®.
If the Airfresh Clean Connect 500 is connected to a mo-
bile device, it can be controlled via the control console
of the housing as well as via the Soehnle Connect app.
UV-C lamp and night-time mode
Press the button (H) once to switch on
the UV-C lamp inside the Airfresh Clean
Connect 500 (UV-C indicator is on). Press
again to activate the night-time mode
without turning off the UV-C lamp (UV-C
indicator light is on, NIGHT indicator light
flashing). Press the (H) button again to
turn off the UV-C lamp (UV-C indicator
light is off, NIGHT indicator light flashes),
or turn off both (UV-C indicator light is off,
NIGHT indicator light is off ).
Night mode
In the night-time mode, you can run the
Airfresh Clean Connect 500 without being
disturbed by additional light sources. Once
you activate the night-time mode, all indi-
cator lights on the device will soon be
turned off without the device switching
off. All previous settings for operating time
and fan speed will remain unchanged. Ac-
tivation of the night-time mode is indicat-
ed by flashing of the indicator light before
the illumination switches off completely.
The unit can run either in night-time mode or in au-
tomatic mode. These two modes cannot be activated
at the same time.

9. Cleaning and care

Cleaning the combination filter
Regular cleaning of the combination filter (1x
month) ensures faultless operation of the Air-
fresh Clean Connect 500 and the greatest possi-
ble room air quality.
Proceed as follows:
1. Switch the device off prior to cleaning and
disconnect the power plug.
2. Turn the device upside down and place it on
a solid surface (2.1).
3. Open the screw cap on the bottom of the
device (2.2).
4. Remove the housing base by lifting it up
(2.3).
5. Remove the combination filter (2.4) and
clean it. Replace the filter and ensure that it is
inserted correctly.
The prefilter is attached to the filter with Velcro. Clean
the prefilter under running water. Make sure the prefilter
is dry before reattaching it to the Soehnle EPA 12
combi-filter. The Soehnle EPA 12 combination filter
should only be cleaned with a vacuum cleaner.
6. Close the device and fasten the screw cap.
Turn the device right side up and place it on
a solid surface.
7. Reconnect the power cord to a power outlet
and switch the device on.
Cleaning the housing
Switch the device off prior to cleaning and dis-
connect the power plug. Clean the housing of
Airfresh Clean Connect 500 with a slightly damp
cloth.
GB
13