Changing The Gas Cylinder - HAEGER GH-42B.002A Mode D'emploi

3. Whilst still pressing down the control knob, press several times on the
ignition button until the pilot flame ignited at the bottom of the burner.
Continue to hold the control knob down for another 15-20 seconds. When
releasing the button and if the pilot flame goes out, repeat the operation.
4. When first igniting a new heater, it may be necessary to hold the control
knob down for a longer time in order to allow gas to flow to the pilot
burner.
5. When the heater is burning at the LOW (1 ) stage, please wait for around 4
minutes. The heating element will start glowing and will become red. After
that you can turn the control knob to the MEDIUM (2 ) position, again
wait around 4 minutes in this position. Finally, you can turn the control knob
to the HIGH (3
NEVER PUT THE APPLIANCE DIRECTLY ON THE HIGH (3
OF THIS THE HEATER MIGHT NOT BE ABLE TO DIGEST THE GAS IN A PROPER WAY
AND THERE MIGHT BE EXCESSIVE FLAMING COMBUSTION.
6. In order to shut off the heater, you need to turn back the control knob to
the start position and close the cylinder valve fully (in clockwise). The
heater can only be shut off by closing the gas cylinder valve fully. It cannot
be turned off by the control knob.
Safety devices (FFD, ODS, Anti-Tilting)
The heater incorporates several safety devices that will shut down the heater in
unsafe conditions.
1. In case of accidental flame failure, the heater will shut down
automatically.
2. The heater will shut down if the ventilation in the room is not sufficient or
when the heater is placed in a small room. Turn off the heater, ventilate
the room well, and wait 5-10 minutes before re-lighting the heater.
3. This heater incorporates an "anti-tilt" switch that automatically shuts off the
burner in the event of tipping. Ensure the heater is in the vertical position.

Changing the gas cylinder

• Gas cylinders must be replaced in a flame free environment.
• Do not smoke while changing the gas cylinder.
• Turn off the gas cylinder valve or regulator fully (clockwise) and take the
empty cylinder out of the heater.
• Do not attempt to remove the regulator while the heater is still running.
• Make sure that the heater is extinguished completely.
• Remove the regulator from the empty cylinder.
Instructions for use
) position.
English
) POSITION. AS A RESULT
7