HAEGER GH-42B.002A Mode D'emploi page 7

placed. Screw the pressure regulator onto the cylinder, keeping these
warnings in mind:
a) check that the gasket seal is in good condition,
b) attach
counterclockwise,
c) carefully check that there is no gas leaking from the connection,
using soapy water: if there is a leak, bubbles will form; tighten the
connection more or seek professionally qualified service.
Warning:
do not check for gas leaks when the appliance is hot but
wait until it is cold.
7. Place the cylinder in its compartment, taking care that the tube is not
twisted or choked and isn't touching hot parts.
8. Hook the rear cylinder cover on the cabinet, fixes it with the screws
supplied.
9. The appliance has to be installed with the cover of the gas cylinder fixed
to the cabinet. Use the stove only with a 15kg cylinder placed in its
compartment.
10. To replace the cylinder, make sure that its tap is closed and that there are
no open flames (lit oven, etc.) or sources of heat in the place where you
are working; we recommend that you check that the gasket seals of the
regulator and flexible rubber tube are in good condition and replace
them, if necessary.
11. Do not mishandle the connections or other components.
12. Do not turn the cylinder upside down to completely use its contents: this
releases liquid residues left in the tank that will irreparably damage the
heater.
13. Do not disconnect the pressure regulator from the cylinder when the
cylinder tap is open.
14. The manufacturer will not be responsible if one of the above points is
disregarded.
Installation
1. Use the heater only in well-aired rooms. In the room where the heater is
placed there must be as much air as it is necessary for the combustion.
The room must have two breaches of 105cm² for the air change.
2. The heater must be installed on a flat, stable surface.
3. Do not install or use the heater in bathrooms; in bedrooms; in basement
floors, in upper floors or in rooms with a volume less than
with the risk of fire (garage).
Instructions for use
the regulator to the tap, screwing the
15m3
English
nut tightly
; in places
5