Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• 2 powerful LEDs: to illuminate in dark circumstances and as warning
signal
• user-friendly setup via push buttons
• comes with USB cable, bike bracket, window bracket and strap bracket
5. Overview
Refer to the illustrations on page 2 of this manual.
1
Camera Lens
2
LED Light
3
Microphone
4
Power button + LED Press
5
Live Record
6
Snapshot
7
LED Button
8
LED Flash
9
Open
10 Wrist Strap Hook
11 Mount Base
12 Battery
compartment
13 USB Port
14 Micro SD Slot
6. Use
Before use
• Open the housing. To do this, press the open button [9] and gently slide
the housing open towards the back.
• Insert batteries (refer to §8)
• Insert a micro SD card (not incl.) into the card slot [14]. Refer to the
indication next to the slot for the right direction. Only use a new card from
a reliable brand. Approximate recording times:
HD 1280x720 (30FPS)
Recording Time (Hours)
• Press the power button [4] shortly to set the camera in standby-mode. A
red LED under the power button lights up.
• Connect the USB-port [13] to a PC using the included cable. The LED
turns blue. The batteries are now being charged. Make sure batteries are
28.07.2010
CAMCOLVC13
Clean the lens by soft dry cloth before usage
2 Powerful LED to light/flash during low light
situations.
Advanced sensitivity microphone to record audio
to turn on/off the camera
Press
to record live videos or stop recording.
Press
to take single JPG photos
Press
to turn on/ off LED light
Press
to flash LED light or stop flashing LED
Push
to open the casing
Attach wrist strap (included)
To support brackets and straps
Holds 2 rechargeable lithium batteries.
Plug in USB cable to upload data
Insert Micro SD card (up to 32 GB supported)
2GB
4GB
1
4
8GB
2
4
16GB
32GB
8
16
©Velleman nv
Publicité
Table des Matières
