Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Always take of the clip light before washing textiles, the light is atta-
ched to.
DANGEr! Short-circuit hazard! A short-circuit could be caused if
moisture enters the product.
» Never immerse the product into water.
» Take care that no liquids enter the casing of the product.
Charging the battery
The product carries an integrated USB-plug below the rubber cap (5) at
the bottom of the lamp.
» Carefully remove the rubber cap.
» Connect the USB-plug (4) to an appropriate 5 V DC USB-slot, like on a
computer.
» A red control lamp will shine while the device is being charged. The
control lamp turns green when the device is fully charged.
» If the control lamp does not light up, unplug the USB-plug, turn it 180°
and plug it in again.
Publicité
Table des Matières
