Main Components - Zibro Kamin RS 145 E Manuel D'utilisation

GENERAL DIRECTIONS FOR USE
Below you will find the main steps to be taken for
using your heater. For more details, please refer to
the MANUAL (pages 41 ff.).
1
Remove all packaging materials (refer to Section A, Fig. A).
2
Fill the removable tank ¾ and wait 30 minutes before you
ignite the heater (refer to Section B, Fig. I).
3
Insert the batteries into the battery holder
(refer to Section A, Fig. F).
4
Check whether the combustion chamber ¿ is fully upright
(refer to Section A, Fig. E).
5
Ignite the heater by turning the knurled wick adjustment
knob · as far to the right as possible and then gently push the
ignition button » (refer to Section C, Fig. K and L).
6
Prior adjusting the burner (refer to Section D), let the heater
heat up for 10 to 15 minutes.
7
Switch off the heater (refer to Section E).
•
The first time you ignite your heater it will smell
like 'new' for a short time.
•
Store your fuel in a cool and dark place.
•
Fuel has a limited shelf life. Start every heating
season with new fuel.
•
The right quality of fuel will be assured, when
you use Zibro Plus for your heater.
•
If you change to another brand and/or type of
parrafin oil, you must first finish up all the
remaining fuel in the heater.

MAIN COMPONENTS

³
Safety device for
emergency stop
·
Knurled wick
adjustment knob
»
Ignition
Combustion
chamber
´
Combustion
chamber handle
²
Fuel indicator
¶
Grill
º
Lid for removable
tank
¾
Removable tank
µ
Fuel gauge
removable tank
¸
Wick height lock
¹
Ignition coil
Battery holder
Ventilator shaft
On/Off button
ventilator
Information display
Plug
4
39
RS 145 E