Publicité
Les langues disponibles
Les langues disponibles
It is important that you do not glue
the MTA to the pipe first, and then
thread the wall spout onto the MTA.
Doing it this way may lead to the wall
spout being set out of level. If not level,
you will be able to make small
adjustments to level the spout, but
this may not be able to perfectly level it.
When plumbing multiple spouts off of one
pump, run a main feed line along the back
of the wall, teeing up to the individual
spouts (see Figure 4). If plumbing multiple
spouts at the same height, individual ball valves are not needed. If the spouts
vary in height, it is best to install a ball valve in each line feeding the spouts to
provide more control over the flow. When running more than three spouts,
the main feed line should be increased to at least 2".
Figure 4
Maintenance:
To clean the interior of the Wall Spout, first turn off the power to the pump to
avoid the chance of electrical shock. Remove any large obstructions that may
be present and wipe down the interior of the spout with a non-abrasive cloth.
Atlantic Colorfalls and Fountain Treatment (Item # CFFT800) can be used to
help keep the Wall Spout and the water in your basin clean.
Warranty:
Wall Spouts carry a one-year limited warranty. This limited warranty is extended
solely to the original purchaser commencing from the date of the original
purchase receipt and is void if any of the following apply:
•
The Wall Spout is installed in a load bearing application.
•
The Wall Spout has been misused or abused.
•
The Wall Spout has been disassembled or modified other than as
described in this manual.
This warranty excludes labor/costs of labor for removal or installation of
any product.
1½" PVC
Figure 3
2" feed line
3
Publicité
