Emptying The Dust Bag; Maintenance; General Maintenance - RIDGID R86064 Manuel D'utilisation

OPERATION

EMPTYING THE DUST BAG

See Figure 5, page 11.
For more efficient operation, empty the dust bag when it is no
more than half full. This will permit the air to flow through the
bag better. Always empty and clean the dust bag thoroughly
upon completion of a sanding operation and before placing
the sander in storage.
WARNING:
Collected sanding dust from sanding surface
coatings such as polyurethanes, linseed oil, etc.
can self-ignite in the sander dust bag or elsewhere
and cause fire. To reduce the risk of fire always
empty the dust bag frequently (10-15 minutes)
while sanding and never store or leave a sander
without totally emptying its dust bag. Also follow
the recommendations of coating manufacturers.

MAINTENANCE

WARNING:
When servicing, use only identical replacement
parts. Use of any other parts could create a hazard
or cause product damage.
NOTE: ILLUSTRATIONS START ON PAGE 10 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.
This product has a 90-Day Satisfaction Guarantee Policy, as well as a Three-year Limited Warranty.
For Warranty and Policy details, please go to www.RIDGID.com or call (toll free) 1-866-539-1710.
To empty the dust bag:
 Remove the battery pack.
 Turn the dust bag counterclockwise to the UNLOCK
position to remove it from the sander.
 Shake out the dust.
 Reattach the dust bag to the sander by sliding the bag
on to the dust port and turning it clockwise until the bag
is in the LOCK position.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
8 - English