Plein Air CONVEX SLIM TURBO TCVP-2000 Mode D'emploi page 12

and must be equipped with an earth cable.
3. The appliance must be used only for its intended use, that is, as a heater for domestic heating. Any use other
than its intended purpose shall be deemed to be improper and hazardous.
4. The manufacturer shall not be held responsible for damages derived from misuse of this appliance, do not
assuming any responsibility in case of incorrect use that will decline any warranty.
5. Always place the fan heater on a flat and even surface, it should not be exposed to vibration or mechanical
stress.
6. The appliance has dangerous components that must be kept out of the reach of children.
7. Never connect the power cord to extensions or triple plugs. Do not pull or damage the power cord. Before
any maintenance operations, disconnect the plug from the mains socket.
8. The power cord must never be in contact with the hot surfaces of the appliance.
9. Do not lay the power cord under a carpet. Do not cover the power cord with a cover or similar elements.
Pay attention not to place the power cable where it is likely to get into people's way.
10. If the appliance does not work properly, immediately turn it off and disconnect it from the mains socket. For
repairs, contact a technical support center authorized by the manufacturer, and require that original spare
parts be used. Using parts that do not conform to the product may seriously compromise its correct
operation.
In order to unplug the appliance, select "0" and disconnect the plug from the power socket.
11.
ASSEMBLING FOR FREESTANDING USE
Before using the appliance, fix its feet (included separately in the box) to the appliance.
The feet must be fixed to the appliance base using the 4 self-threading screws supplied,
making sure they are correctly placed in their corresponding positions on the bottom of
the appliance.
WARNING: The convector heater must always be positioned at a minimum safety
distance of at least 1 m away from any inflammable material.
USE OF THE ENVIRONMENT THERMOSTAT MODE
NOTE: when the appliance is set at work for the first time or after long
periods of inactivity, it could give a slight smell. This smell will disappear a
little while after turning it on.
Position the appliance as described above and connect the plug to the mains
socket.
Turn the thermostat knob fully clockwise until the maximum position then
turn the adjustment knob to the position "II". Once the heating element is
activated, the luminous indicator lights up.
Once the desired temperature has been reached in the room, turn the
thermostat knob anticlockwise, until hearing a click and the luminous
indicators on the switches go out. In this way, the temperature will be
automatically adjusted and kept constant along time by the thermostat, which
will automatically activate the appliance when the ambient temperature falls
below the desired temperature.
Two different heating power levels are available (750W/2000W).
For minimum power, turn the adjustment knob to the position "I".
For maximum power, turn the adjustment knob to the position "II".
TURBO FAN MODE
Turn the adjustment knob to the position "I" or "II", according to the desired power.
MAINTENANCE
1. This appliance requires no maintenance except cleaning of its external surface.
2. Before cleaning the appliance, disconnect it from the mains socket and wait for it to cool down.
3. Dust the intake grill regularly, removing rope yarn, down or any other foreign matter that might limit regular
air circulation.
4. To clean external surfaces, use only a soft moistened cloth. Do not use solvents.
DT Istr (TCVP2000) _ Rev 2_06/18
INSTRUCTIONS FOR USE
TCVP2000
12/22