Philips 4500i Série Mode D'emploi page 19

Problem
The appliance
produces a
strange smell.
The appliance is
extra loud.
The appliance still
indicates that I
need to replace a
filter, but I already
did.
Error code "E1"
displays on the
screeen.
Error codes "E2",
"E3", "E4" or "E5"
displays on the
screen.
Possible solution
• The first few times you use the appliance, it may
produce a plastic smell. This is normal. However, if the
appliance produces a burnt smell even if removing
filters, contact your Philips dealer or an authorized
Philips service center. The filter may produce smell after
being used for a while because of the absorption of
indoor gases. It's recommended that you reactivate the
filter by putting it in direct sunlight for repeated use. If
odor still exists, replace the filter.
• If the appliance is too loud, you can change the fan
speed to a lower fan speed level. When using the
appliance in a bedroom at night, choose the silent
speed.
• Perhaps you did not reset the filter lifetime counter.
Switch on the appliance. Then touch and hold the reset
button ( ) for 3 seconds.
• The motor has malfunctions. Contact the Consumer
Care Center in your country.
• The sensor has malfunctions. Contact the Consumer
Care Center in your country.
EN
17