Getting Started; Mouse; Keyboard; Controller - Hama 00054478 Mode D'emploi

I. Getting Started
1. First, check whether your accessory is compatible
with the Speedshot Ultimate.

Mouse

• With USB connection
• Wired
• Very high dpi resolution
• On the Speedshot compatibility list
• Recommendation: Hama uRage Illuminated
mouse (Hama item number: 113722)

Keyboard

• With USB connection
• Wired
• Without macro/hub function
• Without mouse function
• On the Speedshot compatibility list
• Recommendation: Hama uRage Illuminated
keyboard (Hama item number: 113728)

Controller

• Xbox360: Use on the Xbox360 requires a wired
Microsoft Xbox360 controller. Unfortunately,
a wireless controller with a charging kit will
not work. This is because the charging kit can
transmit power, but not data.
• PS4: Use on the PS4 requires a fully charged
Sony DualShock 4 controller.
• Xbox One: Use on the Xbox One requires a
Microsoft Xbox One controller.
2. Connect the mouse and keyboard to the two USB
ports on the front of the converter. The interface on
the side is intended exclusively for connecting the
controller. However, it does not matter which of the
two front interfaces you use to connect the mouse
or keyboard.
3. Now, disconnect the other controllers from your
console. For wireless controllers, you have to log out
of the console or switch it off.
4. Connect the controller (not required for the PS3)
4.A) For use with the PS4 & Xbox One
Take the included Micro-USB cable and connect
it to the USB port on the side of the Speedshot.
Connect the other end of the Micro-USB cable to
your switched-off Sony DualShock 4 or Xbox One
controller.
4.B) For use with Xbox 360
Connect your wired Microsoft Xbox360 controller
straight to the USB port on the side of the converter.
5. Now, connect the Speedshot's connection cable
straight to your console using an available USB port
(never a USB hub)
6. Next, press the home button in the middle of the
Speedshot converter to start up the Speedshot. Pay
attention to the Player LEDs (1-4) on the converter.
The Speedshot always connects to the next available
channel. If you want to play as Player 1, switch the
other controllers off and repeat the procedure so
that the Player 1 LED lights up.
7. The LEDs "M" (for mouse) and "K" (for keyboard)
on the converter let you see if the mouse and
keyboard have been correctly recognised. If the LEDs
are not lit up as in the image below, try connecting
the converter again or, if possible, try to connect a
different keyboard or mouse. If you have problems,
you can either consult Section VI of the operating
instructions or contact our Customer Support team
(contact details in Section VII).
3