Configuration - Vyaire Micro 1 Mode D'emploi

Configuration

When the unit is first turned on it may be configured for your
region. This will set the language, height and weight units, date
format and predicted values set appropriate for your region. It will
also configure the indices to be displayed and whether percentage
predicted or Z-score is to be used to show variation from the norm.
However all of these settings may be customised using the PC
software supplied.
Turn the unit on by pressing the on/off button located at the top of
the device and the following will be displayed:
Use the up and down arrow keys to highlight the required country
and then press 'Enter' (↵). This procedure is only required when
the unit is first switched on and the selection will be stored for
future use.
It is recommended that the PC software be used to adjust these
settings, if required. Connect Micro I to the PC using the USB
cable supplied. Run the software, and turn on the Micro I. The PC
software will detect that the Micro I is connected. Follow the on-
screen instructions to configure your unit.
15