General; Device Concept; Requirements; Options - Fronius RC Pedal TIG /TMC Instructions De Service

General

Device concept

Requirements

The remote controls can be operated with the following power sources:
RC Panel TIG /TMC:
-
-
RC Panel TIG /BT:
-
-
-

Options

TMC extension 5 m
MagicWave 190 / 230i
TransTig 230i
MagicWave 230i
TransTIG 230i
Only in certified countries
The RC Pedal TIG /TMC and RC Pedal TIG
/BT remote controls allow the welding cur-
rent to be easily adjusted with the aid of a
foot pedal.
The welder's hands remain free, meaning
that in addition to constant welding current
correction, uninterrupted torch guidance is
guaranteed.
When a remote control is connected or a
Bluetooth connection established, the wel-
ding current set on the power source is
deemed the maximum current. The total
pedal travel corresponds to the range from
the minimum welding current to the maxi-
mum welding current.
At low welding currents, the remote control
allows for especially sensitive adjustment.
43,0004,5979
21