Start-Up; Rc Pedal Tig /Tmc: Connecting The Remote Control; Rc Pedal Tig /Bt: Connecting The Remote Control To The Power Source Via Bluetooth - Fronius RC Pedal TIG /TMC Instructions De Service

Start-up

RC Pedal TIG /
1
TMC: connecting
the remote con-
trol
11
2
When the remote control is connected, the remote control symbol is displayed in the status
bar on the power source.
The 2-step, 4-step and spot welding modes can no longer be selected.
RC Pedal TIG /BT:
1
connecting the
2
remote control to
the power source
via Bluetooth
3
Risk of injury and damage from unexpected arc ignition!
Unexpected ignition can be triggered by another pedal remote control connected to the
power source.
► Make sure that the correct pedal remote control is connected to the power source!
► Check MAC address!
Beware when switching the remote control on/off:
Leave the remote control for at least 3 seconds after switching off, otherwise the switch off
will not be detected.
If the device is switched on again too quickly after it has been switched off, the status LED
illuminates for less than 3 seconds.
26
For TIG applications only:
Disconnect the TIG welding torch plug from the TMC connection on the power source
Switch on remote control at the bottom
Switch on power source and activate Bluetooth function
The remote control is ready to use when this is detected and displayed by the power
source.
Confirm Bluetooth settings on the power source if necessary
CAUTION!
TMC
1
2