CMT ORANGE TOOLS CMT333 Manuel D'utilisation page 2

Masquer les pouces Voir aussi pour CMT333:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

INDEX, INTRODUCTION & ASSEMBLY OF THE SET
INDEX
Introduction, General Notes & Set Assembly
Characteristics of the components
Installation & Use
Maintenance & Safety
Information on this publication
This booklet is an integral part of the product. Carefully read the warnings and instructions it contains, as
they provide important indications regarding user safety and maintenance. This manual is used by users
under their own responsibility.
C.M.T. UTENSILI SpA cannot be held responsible or liable to prosecution for damage due to incorrect use
of the documentation.
Keep this manual in a safe place for any further consultation that may be required.
General notes
This manual was prepared with the intention of providing all the indications regarding technical aspects,
installation, adjustment, use and maintenance.
Data and designs are provided for illustrative purposes. The manufacturer reserves the right to make any
modifi cations to the product without prior notice.
If any further information is required, out technical assistance service should be contacted.
Assembling the set according to the type of hinge
Thanks to the following table, assembling the set is extremely easy.
According to the hinge model, the CMT333 multipurpose support, chuck head, two blind hole bits and
hinge drill bit (code 317.350.11) must be ordered.
Make your set
Support modular base
6
=
+
CHOOSE YOUR HINGE
CODE
GRASS
42/11
BLUM
45/9,5
MEPLA
48/9
CMT333
SALICE
48/6
HETICH, WURT 52/5,5
N.B.: blind hold bits are sold individually, like all the other items, so when ordering, it is necessary to indicate a
quantity of two
2
Boring heads
Drill bits
Boring bit
+
+
CODE
CODE
CMT333-4211
CMT333-4595
310.080.12
CMT333-4809
317.350.11
CMT333-4806
310.100.12
CMT333-5255
www.cmtutensili.com
PAGE
This drilling system was designed by CMT for all craftsmen and DIY buffs who require to drill holes for
hinges by various manufacturers in a precise reliable manner.
pag.1
The system is made up of a multipurpose support to which a 3-arbor chuck head with a space between
pag.2
holes that varies according to the type of hinge used can be fi tted.
pag.3
The support is made up of two chromed steel runner bars with springs (1) and a threaded bar (2) for
pag.4
setting drilling depth. On the base, it is possible to adjust drilling distances; from the edge of the panel
to the hinge by means of the stop plate with pin and centre clamp knob (3) whereas, from the underside
of the panel to the hinge, this Is done with a Ø10mm cylindrical bar (not included) that is fi tted in the
hole at the side of the base (4). In the bottom part of the support, there are two side holes for fi tting the
support board (5) or mounting CMT worktables on the plates.
The head is made up of a shaft (6) with a diameter of 8mm (for use on all drills), which allows the rotation
of three bit holder arbors (7), each of which has two dowels for fi tting the bits. The shaft and the arbors
have been burnished in order to avoid the formation of rust.
Two radial ball bearings have been fi tted inside each arbor's head to ensure the utmost drilling precision.
On the front, there is a hole with a sphere (8) for the lubrication of the head with Mobil SHC100.
4
CODE
www.cmtutensili.com
COMPONENT CHARACTERISTICS
1
2
3
5
6
8
7
3

Publicité

Table des Matières
loading

Table des Matières