Controls And Functions - BEGLEC JB SYSTEMS MCD150 Mode D'emploi

ENGLISH
• To avoid condensation to be formed inside, allow the unit to adapt to the surrounding
temperatures when bringing it into a warm room after transport. Condense sometimes
prevents the unit from working at full performance.
• Choose the place where you put your installation very carefully. Avoid presence of heat
sources. Avoid places with vibrations or places that are dusty and humid.
• The player will work normally when installed on a surface with max. 15° inclination.
• Be very careful while handling CDs, do not touch them with wet or dirty hands.
• Discs that are dirty must be cleaned with special designed cloth and cleaning products.
• Do not use CDs that are badly damaged (scratched or deformed) they can damage your
appliance.
• To prevent fire or shock hazard, do not expose this appliance to rain or moisture.
• In order to prevent electric shock, do not open the top cover. If a problem occurs, contact
your dealer.
• Do not place metal objects or spill liquid inside the CD player. Electric shock or
malfunction may result.
• This CD player uses the semiconductor laser. To allow you to enjoy music at a stable
operation, it is recommended to use this in a room of 5°C – 35°C.
• The compact disc player should not be adjusted or repaired by anyone except properly
qualified service personnel.
• This unit may cause interference to radio and television reception.
CLEANING THE CD-PLAYER:
Clean by wiping with a polished cloth slightly dipped with water. Avoid getting water inside
the unit. Do not use volatile liquids such as benzene or thinner which will damage the unit.
CONNECTIONS
• Use the supplied cinch cable to connect the audio output of the CD player with a CD
input on your mixing unit.
• Also connect the fader start cable if your audio mixer has fader start connections.
(Synq® or Pioneer® compatible)
• Connect the mains cable.
JB SYSTEMS
®
OPERATION MANUAL
3/25 MCD150
ENGLISH

CONTROLS AND FUNCTIONS

1. CD ACCESS DOOR: Used to load and unload the CDs. Use the eject button (3) to
open the cover and simply close it by hand.
2. STOP BUTTON: Stops playback immediately. Use this button AT ALL TIMES before
opening the CD access door!
3. EJECT BUTTON: press this button to open the CD access door.
Important: always stop playback first, by pressing the STOP button (2), before using
the EJECT button!
4. SGL/CTN Button: with this button you can choose between "single track mode" and
"continuous play".
• Continuous play: the complete CD will be played without interruption. (mostly
used in pubs)
• Single track: player stops at the end of each track and waits at the beginning of
the next track. The player waits at the first music note of each track. This means
that badly indexed CDs will not interfere with the instant start capabilities of this
CD player. This is a very useful feature for deejays!
5. CUE/STUTTER button: has 2 functions, depending on the playback status:
• STUTTER function: Pressing the CUE button during playback provides an
immediate return to the preprogrammed cue point. Playback starts immediately
from the programmed cue point each time the CUE button is pressed causing a
JB SYSTEMS
®
OPERATION MANUAL
4/25 MCD150