Linea 2000 Domo DO7033 Mode D'emploi page 21

DO7033
To thin hair:
• To thin out the hair, insert the thinning attachment on the cutting unit in the same
way you would a cutting length attachment.
This function reduces the volume of the hair.
CLEANING AND MAINTENANCE
DANGER
Risk of loss of life from electric shock!
• Pull the mains plug out of the socket with earth contact before you clean the device.
• Never hold the mains adapter with wet hands if you want to plug it into the socket
with earth contact or unplug it again.
• Always keep the mains adapter and connection line dry.
WARNING:
Do not clean the hair/beard trimmer by immersing it in water or other liquids,
because the device is not waterproof. Doing so could damage current-carrying parts
(rechargeable batteries).
Cleaning the case:
Use a slightly moist cloth to clean the case.
Cleaning the hair/beard trimmer:
• Switch the hair/beard trimmer off.
• Disconnect the cable from the device and pull the mains adapter out of the socket
with earth contact.
• Remove the cutting length attachment from the device.
• If necessary, wash the cutting length attachments off in running water.
• Then dry the attachments thoroughly.
Press against the teeth of the trimmer head from above with your thumbs to remove
the cutting unit from the holder.
• Use the cleaning brush that came with the trimmer to remove any remaining cut hairs
from the cutting unit .
• When done cleaning, insert the locking clip of the cutting unit into the retaining
opening of the trimmer head holder.
• Snap the cutting unit into place again by pressing lightly from the back.
Tip: To reduce friction, occasionally place one or two drops of cutter oil (included)
between the blades and distribute it uniformly. You can also use any acid-free oil (such
as sewing machine oil).Wipe any excess oil off with a cloth.
21