Machine Information; Technical Specifications - VONROC LR501DC Traduction De La Notice Originale

vice and protect yourself from dripping wax!
• Before each use check the unit and accessories
for damage and function.
• Do not disassemble, burn, or short-circuit bat-
teries and do not attempt to recharge nonre-
chargeable batteries.
• Do not disassemble the unit or attempt to repair
it yourself. It does not contain parts serviceable
by you. In the case of questions or problems,
turn to our customer support.

2. MACHINE INFORMATION

Intended use
The device is intended for repairing surfaces of
laminate, parquet, cork, hardwood floors, wood
and plastic by melting a suitable wax. The device
is not allowed for melting other materials. The
appliance is intended exclusively for domestic
use. Do not use the appliance for commercial or
industrial applications. Operation is only permitted
in a dry environment; contact with moisture must
be avoided at all times.

TECHNICAL SPECIFICATIONS

Model No.
Battery
Weight (without batteries)
Voltage
Power input
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-3.
1. Wax melter
2. Wax melting tip
3. Protection cap
4. On/Off switch
5. Heat button
6. LED light
7. Battery compartment
8. Cleaning scraper with curvature
9. Flattening scraper
10. Abrasive sponge
11. Cleaning cloth
12. Wax sticks (A to K)
WWW.VONROC.COM
LR501DC
2x 1.5V LR6 Size AA
42 g
DC 3V
3W
3. ASSEMBLY
Inserting the batteries (Fig. A2)
This device requires 2x 1.5 V batteries, Type AA/
LR6/Alkaline, for operation.
• Open the battery compartment (7) on the back
side of the device.
• Place the batteries into the battery compart-
ment, following the polarity details as depicted
in it.
• Close and secure the battery compartment.
Replace the batteries when reaching the
operating temperature requires more than
60 seconds.
4. OPERATION
Switching the device ON/OFF
• To switch the appliance on, place the On/Off
switch (4) at the position "ON".
• Press and hold the heat button (5) to heat up
the wax melting tip (2).
Warning! Do not press the heat button (5)
while switching the on/off switch (4).
• Red LED (6) lights up when melting tip is heat-
ing.
• When releasing heat button (5) the wax melting
tip will cool down and the light turns off.
• To switch the appliance off, place the On/Off
switch (4) at the position "OFF".
• After use always place the protection cap (3)
back on the device.
Avoid turning on the device accidentally.
Make sure the device is turned off before
laying it down or storing it.
Preparation of the damaged area (Fig. B)
• The damaged area must be cleaned and flat-
tened before repairing.
• Clean the damaged area with the sharp edge of
the flattening scraper (9).
• Remove all loose residue.
Colour selection to match damaged area (Fig. C)
• Select the matching colour tone.
Tip! When in doubt between two colours, start
with lighter colour.
EN
5