Using The Timer; Cleaning, Care & Maintenance - Caterlite CN203 Mode D'emploi

Cooking using the Temperature Function
Press the FUNCTION button until the Temp light illuminates. Temperature can be adjusted by "
Temperature is from 60°C to 240°C.
Function
Temperature

Using the timer

When in Power or Temperature mode pressing the FUNCTION button again will allow you to enter / view
the timer.
The Timer can be adjusted by "
automatically return to the function mode.
Function
Timer
NOTE: If unsuitable cookware or no cookware is present the induction cooker will beep for
60 seconds before switching off.
Cleaning, Care & Maintenance
• Disconnect from the power supply and allow the appliance to cool before cleaning.
• Use warm, soapy water and a damp cloth to clean the appliance.
• DO NOT use abrasive cleaners or pads.
• Dry thoroughly after cleaning.
• A CATERLITE dealer or qualified technician should carry out repairs if required.
Troubleshooting
Fault
The unit is not working
"E0" on Display
"E1" on Display
"E2" on Display
CN203_ML_A5_v4_20201230.indb 5 CN203_ML_A5_v4_20201230.indb 5
Level Increments
60°C - 240°C
" or " " from 0-180 minutes. Five seconds later, the screen will
Level Increments
0 - 180min
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Unsuitable cookware / no
cookware
Appliance has overheated
Temperature of pan is too
high (Pan is dry or empty)
Default
20°C 180°C
Default
5min 0min
Solution
Check the unit is plugged in correctly and
switched on
Call Caterlite agent or qualified technician
Replace the plug fuse
Check power supply
Call Caterlite agent or qualified technician
Replace with suitable cookware
Check ventilation slots for blockages. Allow to
cool before attempting to use again.
Remove cookware. Allow to cool before
attempting to use again.
UK
" or " ".
5
2020/12/30 16:21 2020/12/30 16:21