Using Your Baby Monitor - Philips SCD489 Mode D'emploi

5 Place the parent unit in the charging base (B-15).
> The POWER light (B-16) lights up red.
6 Leave the parent unit in the charging base until the batteries
are fully charged (at least 16 hours).
> The POWER light (B-16) will stay red, even when batteries
are fully charged.
> When the batteries are fully charged, the parent unit can be
taken out of the charging base and used cordlessly for at
least 8 hours.
> When the battery indicator (
empty and the parent unit beeps, battery power is low.
Place the parent unit in the charging base (B-16) to
recharge the batteries.
Notes:
– Operation time will be 8 hours based on the assumption that
the baby unit will be transmitting 25% of the time and is in
standby mode for the rest of the time (baby does not make
any sound).
– When the parent unit batteries are charged for the first time,
operating time will be less than 8 hours.The batteries will use
their maximum capacity after at least four times charging and
discharging.
– The charging time may be longer if you leave the parent unit
switched on while the batteries are charging.
The parent unit is now ready for use!
1 Place both units in the same room to test the connection.
Make sure the baby unit is at least 1 meter / 3 feet away from
the parent unit.
2 Press and hold the On/Off (y) button (A-1) on the baby unit
for 2 seconds.
> The night light (A-10) lights up briefly.
> The display light (A-11) lights up indicating the current
room temperature.
> Not LinKed lights up on the display and the LINK light
(A-3) starts blinking red as it seeks connection with the
parent unit.
Preparing your baby monitor
) in the display (B-8) is

Using your baby monitor

> 1 m / 3 feet
EN
9