Toto Kiwami Renesse TS170F Manuel D'installation Et D'utilisation page 6

Installation of Handshower
Hanger
1. Drill prepared holes.
NOTE: Make sure they are
1-9/16" (40 mm) apart.
2. Place the mounting plate
to the concave part of the
mounting beads, making
sure that tapped holes of the
beads are facing downward.
3. Fix the beads with the
provided screws.
4. Insert the shower hanger
into the mounting beads and
tighten the hanger screws.
5. Place the hand shower on the
hanger.
Installation of Handshower
1. Place the cover plate on the
handshower adapter opening and
fasten the cover plate nut.
2. Position the notch below and
press the escutcheon into the
cover plate.
NOTE: If the escutcheon is
difficult to attach, apply weak
soapy water to the o-ring.
3. Then, tighten the Handshower
adapter connector to the adapter,
making sure that flex hose outlet
faces below in the end.
CAUTION: Confirm that the gap
between the connector and cover
plate is between 1/32 ~ 3/32 in (1 ~
2.5 mm).
4. Connect the hand shower to the
Flex Hose outlet. MAKE SURE
THAT THERE IS A GASKET.
InSTallaTIon PRoCeDURe
Facing
the wall
6
Handshower Mounting plate
Mounting beads
Screws
Shower hanger
Hanger screws
Cover plate nut
Notch
Facing oor
Escutcheon
Handshower
Handshower
adapter
connector
Gasket
Tapped hole
Facing floor
Handshower
adapter
Cover plate
Handshower
Cover plate
adapter
connector
Flex hose
outlet
1/32～3/32 in
1～2.5 mm