Powerfix Profi Z31780 Instructions D'utilisation Et Consignes De Sécurité page 14

Do not wear loose clothing while you are
working with your product.
Fasten the product through the fastening
holes down on to a workbench / table. En-
sure that the workbench / table and the
product are stable.
CAUTION! DANGER OF INJURY! En-
sure that you do not come into contact with
the cutting disc while working.
Always use the cutting disc safety guard
Use this product only with angle grinders
that have a suitable metal protective guard
around the disc (see Fig. A).
Position this protective guard on the grinder
in such a way that the lower part of the ro-
tating cutting disc is uncovered and the
grinder's protective guard cannot come into
contact with the workpiece.
CAUTION! DANGER OF
FIRE! Cutting metal creates
sparks. Ensure that there are no
ignitable materials in the working area.
Sparks can damage paint, glass and other
surfaces. Do not wear clothing made of ny-
lon or polyester; wear suitable, non-inflam-
mable working clothes.
Ensure that the workpiece is held firmly in
place and lies tightly against the base plate.
Do not use the product on workpieces that
are too large, otherwise they cannot be held
firmly in middle of the vice.
Check before and regularly during use that
the screws, bolts and other fixings are firmly
seated.
Check the product regularly for damage. Vi-
brations can loosen screws, bolts and other
fixings during use.
Never use your product if you discover that
it is damaged in any way.
Ensure that the cutting disc of your angle
grinder is mounted at right angles to the
base plate.
Use cutting discs only and not roughing
discs in this product.
Check the cutting disc of your angle grinder
regularly for damage.
14 GB/IE
Never use a disc if you discover it has any
dents, nicks or other damage. It could disin-
tegrate.
Do not allow parts of your body to come
within working range of the cutting disc until
after it has come to a standstill.
When cutting follow the instructions of the
manufacturers of the electrical power tool
and the cutting disc.
. Use angle grinders that have a cutting disc
5
diameter of 115 or 125 mm only.
Do not allow anyone else to
come within the working range of
the product while you are using it.
Assembly
CAUTION! DANGER OF FIRE! Assem-
ble and use the product on a fire-resistant sur-
face only.
The following tools are required for
assembly:
7 x Open spanners (1 x 8 mm, 2 x 10 mm,
2 x 14 mm, and possibly 2 x 17 mm)
2 x Allen key
1 x Slotted head screwdriver (approx. 5 mm)
Follow these steps:
Fasten the saddle
with the hexagonal socket head screws
20
and washers
23
Fasten the handle
with the projecting screw thread and the cor-
responding nut (see Fig. A).
Note: Please bear in mind that the angle
grinder must be fitted with a suitable cutting
disc before assembly. It is not possible to
change the disc with the angle grinder in-
stalled in the product.
Now prepare for mounting the angle grinder
in the mount
Note: At this point, first check the size of
the handle thread of your angle grinder. It
may be M6, M8 or M10.
on to the base plate
21
(see Fig. A).
22
on to the mount
3
.
24
24