List Of Pictograms Used; Proper Use - Powerfix Profi Z31780 Instructions D'utilisation Et Consignes De Sécurité

List of pictograms used

Read instruction manual!
Observe caution and safety notes!
Caution – electric shock!
Danger to life!
Risk of fire!
Dispose packaging and product in
an environmentally-friendly way!
Angle grinder stand
Introduction
We congratulate you on the purchase
of your new product. You have cho-
sen a high quality product. Familiarise
yourself with the product before using it for the
first time. In addition, please carefully refer to the
operating instructions and the safety advice be-
low. Only use the product as instructed and only
for the indicated field of application. Keep these
instructions in a safe place. If you pass the prod-
uct on to anyone else, please ensure that you
also pass on all the documentation with it.

Proper use

This product is intended to provide a method of
holding a hand-held angle grinder in a fixed posi-
tion while using it for cutting. The product is suita-
ble for most hand-held angle grinders that take a
disc 115 or 125 mm diameter disc. Any use
other than that described above or modification
12 GB/IE
Never leave children unsupervised
with the packaging materials or the
product.
Wear protective glasses, hearing
protection, protective gloves and
dust protection mask.
Do not allow anyone else to come
within the working range of the
product while you are using it.
Avoid any backwards movement
and apply even pressure on the
workpiece.
to the product is not permitted and could lead to
injury and/or damage to the product. The manu-
facturer accepts no liability for loss or damage
arising from improper use. The product is not in-
tended for commercial use.
Description of parts
and quantities
Check that all the items and accessories are
present and that the product and its all parts
have no defects immediately after unpacking
(see Fig. 1). Do not assemble the product if any
of the included items listed below are missing.
Adjustment screw with rubber buffer (short) x 1
1
Metal rod x 1
2
Handle x 1
3
Nut (guard mount) x 1
4
Safety guard x 1
5
Plastic bushing M6 / M8 x 2 each
6
Washer (mounting bolt M6 / M8 / M10)
7
x 1 each
Mounting bolt M6 / M8 / M10 (angle
8
grinder) x 2 each