Cleaning The Dustcup; Cleaning The Filter; Replacing The Belt - Eureka AS2000 Série Guide Du Propriétaire

Maintenance

Cleaning the Dustcup

.
Hold dust cup handle in one
hand and the bottom of dust
cup in the other, turn dust cup
counter clockwise to unlock the
cup from the lid.

Replacing the Belt

Unplug vacuum. Recline cleaner
back. Using Philips screwdriver,
remove 4 screws from hood.
Remove belt from the brushroll and
motor shaft. Loop new belt over
motor shaft and brushroll, onto grey
belt pulley.
Screen
Dustcup
Empty the dust cup into
the trash container. Wipe
debris off screen.
Using thumbs, push down on height
adjust knob, while pulling up on
inside hood edges with fingers. Lift
Grip the brushroll and belt as shown.
Stretch belt and push the right side of
brushroll into grooves. Lower left side of
brushroll into grooves making sure both
sides are secure by pushing down. Rotate
the brushroll with hands to make sure belt is
Hold dust cup handle in one
hand and the bottom of dust
cup in the other, line up arrow
on dust cup with unlock icon
on backside of dust cup. Turn
clockwise to lock the cup to
the lid.
and remove hood.
in center of gray pulley.

Cleaning the Filter

Latch
Pull dust cup latch to release
dust cup. Remove filter
and wash. Allow to air dry
thoroughly (24 hours) before
placing back in dust cup
Lift left side of brushroll out of
grooves. Then lift right side of
brushroll out of grooves.
Line up corners of hood and put
hood tab inside the front of cleaner.
From front to back, push hood
onto base, keeping hood in base
grooves, and line up 4 screw holes.
Replace 4 screws.