General Safety Information - purline CHD120C Manuel D'utilisation

This user manual includes important instructions about
using and maintaining your heater.

GENERAL SAFETY INFORMATION

1. Use this heater only as described in this manual.
Any other use is not recommended by the
manufacturer and could cause fire, electrical
shock, or injury to persons.
2. Make certain that the power source conforms to
the electrical requirements of heater (220-
240V/50Hz).
3. Extreme caution is necessary when any heater is
used by or near children or invalids and whenever
the heater is left operating and unattended.
4. To reduce the risk of electric shock, this plug is
intended to fit in a correct outlet. If the plug of
heater does not fit fully in the outlet, contact a
qualified electrician. Do not attempt to defeat this
safety feature.
5. Where possible, avoid the use of extension cords
because the extension cord may overheat and
cause a fire. However, if you have to use an
extension cord, the cord shall be a 2-wire, with
minimum 1.0 mm² or larger and rated not less
than 1890 watts. Never use a single extension
cord to operate more than one heater.
13
6. Do not operate heater with a damaged cord or
plug or after the heater malfunctions, has been
dropped or damaged in any manner. It must be
changed by a qualified electrician or the
manufacturer to avoid any danger
7. Always close the power switch and unplug power
cord before servicing or moving the heater.
Always unplug heater when not in use.
WARNING : DO NOT DEPEND ON THE ON/OFF
BUTTON OR SWITCH AS THE SOLE MEANS OF
DISCONNECTING POWER WHEN SERVICING
OR MOVING THE HEATER.
ALWAYS UNPLUG THE POWER CORD.
8. Do not insert or allow fingers or foreign objects to
enter any ventilation or exhaust opening as it may
cause an electric shock or fire or damage the
heater.
9. To prevent a possible fire, do not block air intakes
or exhaust in any manner. Do not place heater on
soft surfaces, like a bed, where openings may
become blocked.
10. Always place the heater on a stable, flat, level
surface when operating, to avoid the chance of the
heater overturning. Locate the power cord so the
heater or other objects are not resting on it. Do not
run power cord under carpeting. Do not cover
power cord with throws rugs, runners, or the like.
Arrange power cord away from room traffic and
where it will not be tripped over.
14