Medisana AH 670 Mode D'emploi page 24

3 Operating
GB
3.3
1. Briefly press the button
Use
2. Change the position of the vent opening in the outer or inner circle to
3. The
4. During atomisation, briefly press the
5. Briefly press the
6. During active LED lighting, press the LED LIGHT TIMER button
7. Briefly press the button
3.4 1. Remove the mains plug from the socket.
After 2. Remove the plastic cover
use
3. Dry the water tank and plastic cover if necessary with a soft, absorbent
4. If you do not intend to use the appliance for a prolonged period: Also pour
18
ing. The lighting and atomiser will switch on at the highest power level.
set or adjust the direction and height of the mist output.
button
w
remote control have the following function:
press 1x: high atomiser level (HI indicator light lights up) = produces
a lot of mist / atomiser in constant operation.
press 2x: low atomiser level (LO indicator light lights up) = produces
a little mist / atomiser in constant operation.
press 3x: switch off atomiser.
resp. the MIST Timer button
the atomiser switch off after a certain amount of time (1, 2 or 4 hours)
automatically.
button on the remote control in order to switch on the LED lighting:
z
press 1x: bright light
press 2x: medium brightness
press 3x: soft light
press 4x: switch off lighting
the remote control as many times as necessary in order to have the
lighting switch off automatically after a certain amount of time (1, 2 or
4 hours).
lighting.
maining water. Rinse out the tank with fresh water.
cloth.
away any remaining water in the base
CAUTION! Water must not get into the air vent
soft, absorbent cloth to remove any moisture left inside.
, to switch on the atomiser and the light-
o
on the appliance resp. the button
on the remote control in order to have
u
button on the appliance resp. the LED Light
w
again to switch off the atomiser and the
o
and the water tank
2
t
button on the appliance
w
. Pour out any re-
3
by tipping it over a wash basin.
1
! You can use a
6
on the
on
i