Uponor Fluvia T Push-23 Manuel D'installation Et De Fonctionnement page 3

Uponor Pump Group Fluvia T
U K
Push-23
Before installing the Uponor regulation
units, the installer must read, understand
and observe this mounting/operating
instructions (especially the chapter
„Safety").
Safety instructions and tips
In these mounting/operating instructions the
following symbols are used:
Danger! Risk of an electrical shock. Not
observing these instructions can lead
to serious bodily harm and material
damage.
Caution! Important note concerning the
functionality. Disregarding this note can
cause malfunction.
Operating pressure
Temperature
Time
Designated application
The Uponor Fluvia T Push-23 is used for constant
temperature control of hot water in floor and
wall heating systems in buildings or certain
sections of buildings.
All advices of this mouting/operating instructions
are to be observed when using the Uponor
regulating units. Any other application is not as
directed.
U P O N O R F L U V I A T P U S H - 2 3 • I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
Instructions are subject to technical
alterations. Keep for future reference.
The manufacturer does not accept liability for
damages arising from misusing. Modifications
or changes are only allowed after the
manufacturers approval. Regulating units may
only be repaired by authorized repair shops
named by the manufacturer.
Permitted mounting personnel
Regulating units shall only be mounted, adjusted
and maintained through trained personal.
Untrained personnel may only operate the device
under the supervision of an experienced person.
The mounting personnel must read, understand
and observe the mountin/operating instructions
(especially the chapter „Safety"). The
manufacturer can be held liable only under the
above mentioned conditions.
Disposal
Uponor Fluvia T Push-23 consists of various
recyclable components. Uponor would be
grateful if the components (batteries, plastics,
and electric or electronic parts) are sorted and
disposed of at a suitable recycling centre.
3