Specifications - Dometic GROUP SeaLand MasterFlush 8100 Série Mode D'emploi

Specifications

5.3 Dimensions
Standard-height models
Ref. Dimension
A 18.375 in. / 467 mm
B 14.75 in. / 375 mm
C 18.375 in. / 467 mm
D 17 in. / 432 mm - seat height
E 14.875 in. / 378 mm
F 32 in. / 813 mm - seat lid up
6 Operation
6.1 Toilet system start-up
1 . Turn on water supply to toilet .
2 . Press "Flush" switch (2) and hold for at least five seconds .
3 . Toss several sheets of toilet paper into bowl and repeat
cycle . The bowl should completely clear .
6.2 Normal toilet operation
ADDING WATER TO TOILET BOWL
Press "Add Water" switch (1) and hold until desired water level
is achieved . (Do not press "Add Water" switch too long or
overflow may occur.) More water is usually added only when
flushing solids.
FLUSHING TOILET
Press "Flush" switch (2) down and hold for a few seconds after waste drains from toilet bowl (about
five seconds) . This switch activates a powerful macerator pump that siphons water and waste from the
bowl, macerates, and propels the effluent through the discharge line/holding tank. To use less water for
liquid-only flushes, press "Flush" switch for shorter period of time.
"DRY BOWL" OPERATION
During periods of rough travel, water in a toilet bowl can splash out and into the bathroom area . To
avoid this situation, press "Dry Bowl" switch (3) to drain water completely from toilet bowl . Water is not
added to bowl during or after pressing the "Dry Bowl" switch .
Caution – Do Not Flush Waste with "Dry Bowl" Switch!
To maintain proper cleanliness and operation of the toilet and macerator pump, water
should be used with every flush.
6
3
(fig . , page 2)
Dometic 8100 Series MasterFlush Toilet
Low-profile models
Ref. Dimension
A 15 in. / 381 mm
B 14.75 in. / 375 mm
C 18.375 in. / 467 mm
D 13.75 in. / 349 mm - seat height
E 14 in. / 356 mm
F 28 in. / 711 mm - seat lid up
2
1
3