Toto Wyeth TB230S Manuel D'installation Et D'utilisation page 4

INSTALLATION PROCEDURE - Spout
3. Insert the tube for pop up rod inside
the pre-installed diverter valve.
Push firmly until fully seated. Take
care not to damage the o-rings.
4. Orient spout assembly as shown
and lower onto exposed portion of
diverter valve.
Use hex key to fasten spout to valve
with provided set screw. Tighten as
needed.
5. Pass the pop up rod through the
opening in the spout and thread it
into diverter valve to secure.
INSTALLATION PROCEDURE - Handles
*Actual product may vary in
appearance depending on model.
1. Orient handle assembly and lower
onto the exposed portion of valve until
engaged. Rotate the base (dome) of the
handle assembly to fasten it to the valve.
Repeat for other handle assembly.
NOTE: If handles do not line up exactly
as desired, remove handle from valve
and reinstall one (1) notch over (on
valve).
4