Base Assembly - HAEGER TF-029.003A Mode D'emploi

Base Assembly

1. Carefully turn the fan over, placing it on a smooth surface.
2. Loosen the base locking nut from the bottom of the unit by turning it
anticlockwise. Push it down the length of the power cord. (Fig 1)
3. Run the power cord through the central gap between the two halves (A
and B) of the unassembled base.
4. Connect the two halves by pushing the plastic pegs on each half into the
corresponding slots on the other half. (Fig.2)
5. Align the tower fan on to the base.
Important: Make sure that the power cord passes through the guides (C) on
the rear half of the base. (Fig.2)
6. Pull up the base locking nut and tighten it clockwise.
Operation
Warning: Make sure that the base is properly assembled before
switching on.
• Place your Fan on a level and dry surface, keeping in mind the safety
precautions outlined.
• Plug the fan into a suitable mains socket (see technical specifications for
details).
1. Speed + oscillation control
Note: Make sure the timer dial is in the 'ON' position for normal operation.
• The oscillation control is combined with the speed dial.
• There are 3 adjustable speeds (1- law, 2- medium, 3- high)
• To select speed without oscillation, select one of the three options on the
right of the speed dial (as shown)
• To select a speed with oscillation, select one of the three options on the left
of the dial (as shown).
With
oscillation
Instructions for use
No
oscillation
English
ON—Always on (no timer)
OFF - Fan off
10 - 60 minutes —Timer Set
3