Program Change Mode - Akai Professional MAX49 Guide D'utilisation

SAVE GLOBALS
On this page, press the VALUE DIAL to store your global settings. After "Stored" flashes three times on the
LCD, the global settings are stored in MAX49's internal memory.
OS
This page displays MAX49's current operating system information.

PROGRAM CHANGE MODE

Use the VALUE DIAL to select which message is sent: Program Change or Program Bank.
PROGRAM CHANGE
MIDI Channel: This setting determines over which MIDI channel data is sent. The available settings are
Common, USB A1-A16, and USB B1-B16.
Program Number: This determines the Program number that will be sent. The available range is 000 – 127.
Please refer to your external module's documentation for information on its available programs.
MIDI to DIN: Determines whether or not MIDI data is sent to the MIDI OUT (On) or not (Off). MIDI data will
be sent to MAX49's USB connection regardless of this setting. Since an external module will usually be
connected to MAX49's MIDI OUT, we recommend leaving this set to On.
PROGRAM BANK
MIDI Channel: This setting determines over which MIDI channel data is sent. The available settings are
Common, USB A1-A16, and USB B1-B16.
Program Number: This determines the Program number that will be sent. The available range is 000 – 127.
Please refer to your external module's documentation for information on its available programs.
Msb / Lsb: These determine the MSB (Most Significant Bit) and LSB (Least Significant Bit). The available
range is 000 – 127. Please refer to your external module's documentation for information on its available
programs.
MIDI to DIN: Determines whether or not MIDI data is sent to the MIDI OUT (On) or not (Off). MIDI data will
be sent to MAX49's USB connection regardless of this setting. Since an external module will usually be
connected to MAX49's MIDI OUT, we recommend leaving this set to On.
MACKIE CONTROL & HUI PROTOCOLS
MAX49 can use the Mackie Control or HUI (Human User Interface) protocols to control certain functions in
DAWs that support them. MAX49 has Mackie Control and HUI Programs in its internal memory precisely for
this purpose.
To select/load the Mackie Control or HUI Program:
1. Press [PROGRAM]. (Each time MAX49 is first
powered on, it will automatically be in Program
Mode.) The LCD will show the current Program
name (flashing).
2. Turn the VALUE DIAL to browse through the list
of available Programs.
3. Press the VALUE DIAL to load the desired
Program: Mackie Control or HUI.
IMPORTANT: Your DAW must also be set to receive commands from an external device (i.e., MAX49) using
the Mackie Control or HUI protocol.
Note: As a shortcut, you can hold [SHIFT]
then press one of the following buttons to
access certain Programs:
• [PROGRAM] = the last used Program
• [MACKIE CONTROL] = Mackie Control
protocol
• [HUI] = HUI control protocol
14