Transport Controls - Akai Professional MAX49 Guide D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

SEQUENCER

[SEQ SELECT]: The first two pages of this

section (Pg1 and Pg2) pertain to specific

Sequences (1-4), as indicated at the top of the

LCD. The rest of the pages pertain to the

Sequencer in general. So the first two pages'

settings may vary between the four Sequences,

but the rest will be the same for all Sequences.

Steps: The number of steps used by the Sequencer. The available range is 01-32 steps.

MIDI Channel: This setting determines over which MIDI channel data is sent. The available settings

are Common, USB A1-A16, and USB B1-B16.

MIDI to DIN: Determines whether or not MIDI data is sent to the MIDI OUT (On) or not (Off). MIDI data

will be sent to MAX49's USB connection regardless of this setting.

Keyshift: When Keyshift is set to On, you can transpose the Sequence in real time (as it is playing) by

pressing a key on the keyboard once, which will "latch" it to that new transposition. When Keyshift is set

to Off, you can only transpose the Sequence by holding down a key; it will return to the Default Key

when the key is released.

Default Key: The default key of the Sequence.

Scale: The scale used by the Sequencer. When a scale other than Chromatic is selected, the faders

will be limited to selecting only the notes available in the scale, which can be useful for avoiding

unintentionally out-of-key notes! The available settings are Chromatic, Major, Dorian, Phrygian, Lydian,

Mixolydian, Minor, Locrian, Minor Melo (Melodic Minor), Minor Harm (Harmonic Minor), PentaMajor

(Major Pentatonic), PentaMinor (Minor Pentatonic), Blues, AlteredDom (Altered Dominant), DimWhlHalf

(Diminished Whole-Half-Step), and Whole-Tone.

Start / Stop: This determines what message will start/stop the Sequencer. The available settings are:

• Note On / Note Off: The Sequencer will play when [SEQ ON/OFF] is activated and a key on the

keyboard is pressed. If Keyshift is On, the Sequence will be automatically transposed to that key.

• Seq On/Off: The Sequencer will play when [SEQ ON/OFF] is pressed.

• Play / Stop: The Sequence will play when Play ( ) is pressed and stop when Stop ( ) is

pressed.

[SEQ NOTE]: This is a representation of the steps in a Sequence. Use the CURSOR buttons to navigate

through the "grid" format.

Step: The step number.

Note: The note being played for that step. You can also set the note by touching the TOUCH FADERS.

Velo: The velocity of the note being played for that step.

[SEQ CC]: This is a representation of the steps in a Sequence. Use the CURSOR buttons to navigate

through the "grid" format.

Step: The step number.

Value: The value being sent for that step.

CC Number: The MIDI CC# being sent.