Auxiliary Input (Aux-In) - Festool SYSROCK BR 10 DAB+ Notice D'utilisation

ly, the unit will recognize your
Bluetooth device and will automatical­
®
ly attempt to reconnect with the device
it was last connected with. If the last
connected device is not available, the
SysRock will try to connect to the sec­
ond last device, and so forth.
Deleting Bluetooth
► To delete all Bluetooth
ings, press and hold the Preset 4
button [g] until <BT-Reset> shows
on the display. The SysRock will
turn off automatically after the
memory is cleared.
Disconnecting your Bluetooth
► Press the Source button [j] to select
any mode other than Bluetooth
mode.
► Alternatively, press (~2 sec.) the
Bluetooth pair button [f] to discon­
®
nect the link.
► You can also turn off Bluetooth
your Bluetooth
the connection.
If you disconnect the Bluetooth
when you are in Bluetooth
Bluetooth icon will then start to flash,
®
indicating Bluetooth
for pairing.
Using your hands-free call feature
Your unit can be used as a
hands-free accessory for
your phone. When music is
playing through your
SysRock and you receive a call on your
phone it can pause the music automati­
cally to allow you to answer your phone.
► If you receive a call while playing
music through your SysRock, press
device pairings
®
device pair­
®
device
®
®
®
device to disable
®
device
®
mode, the
®
is available again
®
and release the Call button [c] to
answer your phone call.
► Speak in direction of the built-in mi­
crophone [1-8].
Note that a very high volume set­
ting may decrease sound quality.
► Press and release the Call but­
ton [c] to end the phone call.

5.11 Auxiliary input (AUX-IN)

SysRock to permit an audio signal to be
fed into the unit from an external audio
device such as an MP3 or CD player.
► Connect a stereo or mono audio
source (for example MP3 or CD
player) to the Auxiliary input [1-5].
► Press the Source button [j] to select
the Aux mode.
► Adjust the Volume control on your
on
MP3 or CD player (max. 80%) to en­
sure an adequate signal and then
adjust the volume on the SysRock
for comfortable listening.
Never use the Aux-In socket in
rainy or moist conditions to pre­
vent moist from entering the
SysRock. Make sure that the rub­
ber cover on top fits thightly when
operating in a moist environment.
5.12 USB socket for smartphone
charging
Your radio has a USB socket which is
intended only for charging a smart­
phone or similar devices. Charge time
may vary and in some cases may take
longer to charge than when using the
manufacturers charging unit supplied
with the smartphone. The radio can
A 3.5 mm Auxiliary in­
put [1-5] is provided on
the top panel of your
English
23