Festool SYSROCK BR 10 DAB+ Notice D'utilisation page 21

5.8 Using preset stations in
DAB/FM mode
You may store your preferred DAB/FM
radio stations to the preset stations.
There are four memory presets each for
DAB and FM radio. They are used in the
same way for each operating mode.
► Press the Power button [1-6] to
switch on your radio.
► Press and hold (~2 sec.) the Preset
button [b], [c], [f] or [g] until the
display show <Saved>.
The station will be accessible via the
chosen preset button. The preset num­
ber P1 to P4 will be shown in the dis­
play.
Repeat this procedure as required for
the remaining presets. Stations stored
in preset memories may be overwritten
by retracing the steps above.
Recalling preset stations in DAB/FM
mode
► Press the required Preset but­
ton [b], [c], [f] or [g] to tune to the
station stored in preset memory.
5.9 Clock time - automatically
updating the clock
Your radio will normally update the
clock time [d] automatically using the
DAB or FM RDS-CT signal.After a power
failure the radio will then set its clock
the next time that you turn on the radio
in DAB or FM mode.
NOTE: If no signal is found you
should either position the radio or
its aerial so that a signal can be
received.
When you set the clock time using the
FM RDS (Radio Data System) function,
your radio will synchronize and display
clock time [d] whenever it tunes to a ra­
dio station using RDS with CT signals. If
the station has sufficient signal
strength the clock will automatically
synchronize within one or two minutes.
The radio clock time will be valid for 24
hours each time the radio time is
synchronized with RDS CT.
If no RDS-signal is received, the
clock time is not shown.
5.10 Listening to music via
Bluetooth
®
You need to pair your Bluetooth
with your SysRock before you can auto-
link to play/stream Bluetooth
through your SysRock. Pairing creates a
"bond" so two devices will recognize
each other and establish a link that en­
ables data transfer.
Pairing your Bluetooth
first time
► Press the Source button [j] to select
the Bluetooth
®
The Bluetooth
flashes to show the SysRock is discov­
erable.
► Activate Bluetooth
device according to the device's
user manual to link up to the
SysRock.
► Locate the Bluetooth
and select <SysRock DAB>. Some
mobile devices (which are equipped
with Bluetooth
than the BT2.1 standard.), require
entering the pass code "0000".
Once the connection is estab­
lished, the Bluetooth
flashing and display a check mark next
English
streaming
device
®
music
®
device for the
®
mode.
status icon
®
on your mobile
®
device list
®
interfaces older
®
icon will cease
®
21