Note: To make sure you brush evenly throughout the
mouth, divide your mouth into 4 sections using the
Quadpacer feature (see chapter 'Features').
6
Brush each section for 30 seconds for a total
brushing time of 2 minutes. Start with section
1 (outside top teeth) and then brush section
2 (inside top teeth). Continue with section
3 (outside bottom teeth) and inally brush
section 4 (inside bottom teeth).
7
After you have completed the brushing
cycle, you can spend additional time brushing
the chewing surfaces of your teeth and areas
where staining occurs. You may also brush your
tongue, with the toothbrush switched on or
off, as you prefer.
The Sonicare is safe to use on:
- Braces (brush heads wear out sooner when used
on braces)
- Dental restorations (illings, crowns, veneers)
Note: You can switch the toothbrush on or off at any
time by pressing and holding the power on/off button
for 2 seconds.
clean and White mode brushing
instructions
The Clean and White mode combines 2 minutes
of Clean mode for a whole mouth clean, with an
additional 30 seconds of White mode to focus on
the visible front teeth.
Brush the irst 2 minutes as instructed in steps
1
1-6 above.
2
After the 2 minutes of Clean mode, the White
mode begins with a change in brushing sound
and motion. This is your signal to start brushing
the upper front teeth for 15 seconds.
EngliSH
11