Assembly Instructions; Shelving Use Requirements - Gladiator Garageworks GARS774XEG Instructions D'assemblage

Shelving Use Requirements

All Rack Shelf Sizes: Maximum weight limit is 2,000 lbs
■
(907 kg) for each shelf, not to exceed 8,000 lbs (3,628 kg)
for the entire shelving unit.
Unpack
WARNING
Excessive Weight Hazard
Use two or more people to move shelving.
Failure to do so can result in back or other injury.
NOTE: Use one person to assemble shelving and two people to
move it.
1. Remove and verify the contents. See the "Parts" section
to sort out all of the parts.
2. Dispose of/recycle all packaging materials.
Assemble & Complete
No tools or hardware required.
■
IMPORTANT:
Use one person to assemble shelving and two people to
■
move it.
Determine shelf spacing before assembly.
■
NOTE: It is recommended to space the shelves equally
from top to bottom of the shelving unit and build it from
the bottom up. See the "End Frames/Support Beams"
illustration.
Prior to assembly, refer to the sticker located on the bottom
■
of one of the welded-end frame assemblies (P4) and record
model and serial numbers on the included warranty page.
There are many benefits of registering the product. Find
out more and register the product online at
www.gladiatorgarageworks.com.

ASSEMBLY INSTRUCTIONS

Support Beam Orientation
End Frames/Support Beams
P4
P2
NOTES:
It is recommended to put the first shelf in slots 1 and 2
■
from the bottom, the second shelf in slots 8 and 9 from the
bottom, the third shelf in slots 9 and 10 from the top, and the
fourth shelf in slots 1 and 2 from the top. Keep two of the
shelves on the bottom half of the shelving rack.
The tie channel supports (P3) provide load support and
■
structural integrity.
All tie channel supports (P3) must be assembled as shown
■
in the "Tie Channel Support Assembly" illustration.
P2
5