General Safeguards; Technical Data - Q-Connect COMB BINDER 12 Mode D'emploi

1 Edge guide
2 Punching Channel
3 Punching and Binding Handle
4 Binding Mechanism
5 Waste tray
SEtup
Assemble the handle at the vertical start position.
EDgE alIgNMENt
The adjustable Edge Guide allows pages of various sizes to be
accurately aligned for the best punching results.
Move the edge guide left or right and stop at the required position.
Test punching the scrap sheet and re-adjust if necessary.
puNChINg
With the Punching Handle in the vertical position, align sheets or
covers and insert the edge to be bound into the Punching Channel
and ensure they are aligned to the Edge Guide. Pull the Punching
Handle all the way down.
The COMB BINDER 12 can punch max. 12 sheets of 80 gsm paper
at once. Punch max. 1 plastic covers at a time.
Move the punching Handle upwards again and remove the
punched document.
BINDINg
Place a plastic comb with the side to be opened upwards onto the
Binding Mechanism. Push backwards the Punching Handle so far
that the comb is opened enough.
Position the punched sheets vertically in the open comb. Locate
the punched holes over the open comb fingers and rotate the
sheets forward onto the comb. When all the sheets are loaded
onto the plastic comb, release the Binding Handle to its original
position to close the plastic comb completely. You can now
remove the bound booklet and enjoy your finished work.
EMptyINg thE waStE tRay
Take out the waste tray from the back of the machine. For best
results, empty the tray regularly.
3

gENERal SafEguaRDS

Place the comb binder on a secure and stable work table to
prevent it from falling and causing personal injury and damage to
the machine.
Use the machine only for its intended purpose.
Always test the machine with some scrap paper before punching
the final document.
When punching plastic covers, we recommend to punch the cover
with a sheet of paper on both sides.
Empty the waste tray regularly.
Lift the machine from the bottom, not from the lids or handles.
Unauthorised maintenance is not allowed.
tEChNIC al Data
Punching capacity: 12 sheets (80gsm).
Number of punches: 21 rectangular holes and 4 round holes
Binding capacity: 450 sheets.
Max. Binding Comb: 51mm.
Adjustable Edge Guide
t
W W W . Q - C O N N E C T . C O M