Applications; Environmental Protection - PROLUMIA IP20 Manuel D'utilisation

ATTENTION
Please read the following instructions carefully to ensure that mounting operation will be carried out correctly. These instructions
should be properly preserved for future reference.
1

APPLICATIONS

A. INDOOR
I. Dry area: IP20, LED Strip Bronze series.
II. Humid area: IP62, LED Strip Silver series.
III. Wet area: IP68, LED Strip Gold series.
B. OUTDOOR
I. Always use IP68, LED Strip Gold series.
2 COOLING
LED strips generate (depending on the type (power/m)) more or less heat. The lifetime of the LED strip is largely influenced by the actual cooling.
For proper cooling there are various types of cooling profiles available (model numbers: 46290xxx). LED strips with a power of 9.6W per meter
or higher must be installed with a cooling profile (whether or not architecturally implemented). This can (for example) also be a metal surface.
For recessed mounting of the LED strip, a (recessed) aluminum profile should be used. On both sides of the aluminum profile must be sufficient
space (minimum of 2.5mm) to provide proper cooling. When applying a lens for covering, please shorten the lens by 15 mm on each side
to create a natural airflow.
3 POWER SUPPLY
The supply voltage must not exceed the specified operating voltage of the LED strip (12V or 24V). Most of the power supplies have a possibility
to slightly adjust the output voltage if necessary.
4 MOUNTING
I. Provide sufficient cooling of the LED strip.
II. LED strips with a 3M double-sided adhesive strip can only be mounted on a flat, dust and grease free surface. Attention: To mount the IP68
LED strip, please use the included mounting clips also.
III. LED strips can only be shortened at the indicated marks.
IV. For a proper waterproofing finishing of the IP68 LED strip, the enclosed end caps and glue must be used. The IP62 LED strip can properly
be sealed when applying a heatshrink tube which is equipped with a adhesive layer.
5 CONNECTIONS
I. LED strips can not be connected to one another. The maximum connection length is 5m.
II. LED strips with a power > 9.6W per meter should be powered on both sides.
III. We advise to calculate an extra margin of at least 10% of the maximum output power when choosing the appropriate power supply.
IV. Please assure proper ventilation of the powersupply and make sure the heat generated by the powersupply can be properly discharged.

ENVIRONMENTAL PROTECTION

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.
www.prolumia.com
3