Supplied Parts; Assembly - Sony PSS-650P Manuel D'installation

Supplied Parts

Outer pipe (1)
Wiring cover (for inner pipe) (3)
Wiring cover (for outer pipe) (3)
Fall prevention wire (1)
K6×12 screws (4)
P4×6 screws (4)
P5×12 screws (4)
Installation Manual (this document) (1)
10
Supplied Parts / Assembly
Inner pipe (1)

Assembly

When tightening screws and bolts, tighten within the
rated torque specifications using a torque screwdriver or
torque wrench. The tightening torque values for screws
and bolts are given below.
M4 screws: 1.4 ± 0.5 N·m
M5 screws: 1.4 ± 0.5 N·m
M6 screws: 2.5 ± 0.5 N·m
1
Attach the inner pipe and outer pipe to the PSS-650
Projector Suspension Support adjustment bracket
(A) and ceiling mounting bracket (B), and adjust
the height (see page 11).
2
Join each pipe using the six K6×12 screws (a).
3
Attach the six P4×6 pipe retaining screws (b) and
the six P5×12 rattle prevention screws (c).
(c)
(b)
(a)
(a)
Inner pipe
(b)
(c)
(a)
(a)
Outer pipe
(c)
(b)
(a) (a) (a)
(a) (a) (a)
(A)
(B)
(c)
(b)
(b)
(c)
(c) (c) (c)
(b) (b) (b)